Inductive Current Clamp CT 120 Amp For AC Measurement Brand New
The GFUVE Current Clamp CT Q13-3 allows current measurements
without cutting off the circuit by clipping onto the current
conductor. It can measure AC current via working with DMMs, data
loggers, power meters, power quality analyzer. Clamp CT Q13-3 is a
high-safety current clamp with CE certification.
Features
Measurement range of 1mA to 120A AC
Improved ergonomic design and easy operation
High content nickel metal core
Low phase shift for power measurement
Small, compact size
Jaw opening accommodates conductors up to 13mm diameter
Designed for DMMs, loggers, recorders and oscilloscopes
40Hz to 10kHz response
1mA/A AC output signals
Designed to EN 61010, 600V CAT III safety standard
UL, CE mark
Applications
Power quality measuring
Measuring around cable bundles
Power load monitoring
Waveform analysis
Energy meter calibrator
Measuring in breaker panels
HVAC
Residential and commercial sites
Data logging/recording
Parameter
| Electrical parameters |
| Ratio | 1000: 1 or 2000:1 (customized) |
| Accuracy class | 0.1%, 0.2% |
| Primary current | 0 - 100A AC |
| Secondary current | 0 - 100mA AC (customized) |
| Max. Cont. Input current | 120A |
| Over voltage category | CAT III 600V |
| Output signal (AC current) | 100mA AC at nominal input current |
| Output signal (AC voltage) | 100mV,1V AC at nominal input current |
| Frequency range | 40Hz-2000Hz |
| Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
| Temperature range | -20°C to +55°C |
| Output | 2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors | 600 V |
| Standard | EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation | Clamp type |
| Output mode | Lead output (2.5m) |
| Mechanical parameters |
| Dimensions (L x W x H) (mm) | 45 x 160 x 25 |
| Weight (g) | 300 |
| Holding wire diameter (mm) | φ13 |
| Max. jaw opening (mm) | 13 |
| Color | Black |
| Material | PC+ABS+Polycarbonate, UL94 V0 |
FAQ, following questions will help you to select the matched probe
for your applications.
1. Please determine if you are measuring AC or DC?
GFUVE current clamp CT Q13-3 is for AC measurement.
2. What is the maximum current you will measure?
Clamp CT Q13-3 maximum current is 120A.
3. What size conductor will you clamp onto? This parameter
determines the probe jaw size needed.
Q13-3 can clamp conductor is φ13mm
4. What type of probe output do you need or can you work with (mA,
mV, A, AC, etc.)?
Q13-3 can customize output with mA.
5. What is the working voltage of the conductor to be measured?
GFUVE clamp CT should be used below 600 volts
6. What type of termination do you need: jacks, leads or BNC?
Q13-3 standard has 2.5 meters leads. We can offer jacks or BNC… as
options.
7. If you cannot find information you need or would like
assistance, contact us today. We have designed many more probes
than those shown in this catalog, and we manufacture in Beijing,
China.
