Brand New Inductive Current Clamp CT for Bus - Bar Output 5V Class
0.5
The GFUVE brand new current clamp CT Q70-3 can measure 0-1000A
cable and copper bus bar online.
Measuring Efficiency without Power Down:
When Current Clamp CT making a measurement, the current carrying
conductor is not broken and remains electrically isolated from the
measuring devices input terminals. It is not necessary to interrupt
the power supply when using a Q70-3 for taking measurements. so
costly down time can be eliminated.
Features
It is suitable for 1000 A, the following cable, copper bus bar
online measurement.
Holding wire diameter: 60mm×70mm
Dimension: 122mm×275mm×35.5mm
Load capacity: mA output ≤4Ω,
1A output 0.1Ω, 5A output 2.5VA
Installation: clamp type
Output mode: lead output
Applications
Electric energy meter calibrator (on site)
Double clamp type ground resistance tester
Double clamp type phase volt-ampere meter
Digital multi-meter
Multi-function energy meter
Power quality analyzer
Matched instruments
Calibration instrument on site
Parameter
| Electrical parameters |
| Ratio | 1000: 1 or 2000:1 (customized) |
| Accuracy class | 0.2%, 0.5%, 1% |
| Primary current | 0 - 1000A AC |
| Secondary current | 0 - 5A AC (customized) |
| Max. Cont. Input current | 1200A |
| Over voltage category | CAT III 600V |
| Output signal (AC current) | 500mA,1A,5A AC at nominal input current |
| Output signal (AC voltage) | 500mV,1V,5V AC at nominal input current |
| Frequency range | 40Hz-2000Hz |
| Dielectric strength | 3KV 50Hz/60Hz at 1 minute |
| Temperature range | -20°C to +55°C |
| Output | 2.5 meter cable with D01 connector |
| Max. voltage not insulated conductors | 600 V |
| Standard | EN 61010-1, EN 61010-2-032, IEC60044-1 |
| Installation | Clamp type |
| Output mode | Lead output (2.5m) |
| Mechanical parameters |
| Dimensions (L x W x H) (mm) | 122 x 275 x 35.5 |
| Weight (g) | 720 |
| Holding wire diameter (mm) | φ60 x 70 |
| Max. jaw opening (mm) | 60 |
| Jaw color | White |
| Material | PC+ABS+Polycarbonate, UL94 V0 |
Photos
FAQ, following questions will help you to select the matched probe
for your applications.
1. Please determine if you are measuring AC or DC?
GFUVE Q70-3 is for AC measurement.
2. What is the maximum current you will measure?
Q70-3 maximum current is 1200A
3. What size conductor will you clamp onto? This parameter
determines the probe jaw size needed.
Q70-3 can clamp bus-bar with diameter within φ60mm x 70mm
4. What type of probe output do you need or can you work with (mA,
mV, A, AC, etc.)?
Q70-3 can customize output with A, mA, V
5. What is the working voltage of the conductor to be measured?
GFUVE probes should be used below 600 volts
6. What type of termination do you need: jacks, leads or BNC?
Q70-3 standard has 2.5meter leads. We can offer jacks or BNC… as
options.
7. If you cannot find information you need or would like
assistance, contact us today. We have designed many more probes
than those shown in this catalog, and we manufacture in Beijing,
China.
